Minijet Sand Trap kit
CAD $ 250.00
Protect your motor’s cooling ducts from sand and other sediment by adding this inline filter to collect it.
Spiraling action allows debris to collect in the bottom of the clear bowl with the clean water passing through the mesh in the top. Even if the bowl fills up it will not allow debris into you motor.
Easily monitor the clear bowl at a glance and clean it when needed by unscrewing the clear bowl from the filter and opening the included valve to let dirt out back into the river.
Please choose what size Hose-barb is best fitted for your machine.
Related products
Heat Exchanger
This product is on backorder, with no planned fulfillment date from our supplier. Please see our other heat exchanger product offerings instead.
For engines with 60 HP to 270 HP we recommend This Alternative Product
For engines with 300+ HP we recommend This Alternative Product
Heat exchanger for closed cooled Seadoo and small car motors. End caps are removable for easy winterizing and for cleaning out debris. Each end cap can be rotated and fastened in multiple orientations at 90 degree intervals to facilitate optimal hose management.
Glycol flows through 2 center fittings (1 inch hose size on Sea-Doo’s)
Lakewater flows through two brass end caps (3/4 inch hose size on Sea-Doo’s)
Fittings included are:
2x 3/4 inch NPT to 1 inch barb
2x 3/4 inch NPT to 3/4 inch barb
Rule RM1100B Automatic Bilge Pump
Our go-to fully automatic bilge pump takes the hassle and guesswork out of keeping your boat dry and safe! The Rule RM1100B features a built in water sensor that eliminates the need for a separate float switch and extra wiring. The pump also has built in programming that can turn off the pump when it pump is running but not pumping water to protect the pump, and batteries.
- Capacity: 1,100 GPH
- Volts: 12VDC
- Amperage: 3.8 amp draw at maximum flow
- sold with straight fitting adapters for 1" and 1-1/8" hose.
- sold with snap on strainer that allows for easy cleaning and mounting.
We also offer this in a Bilge Pump Kit with hose, aluminum fitting and Stringer Mounting Plate.
Minijet Electric Trim Actuator Kit
The Minijet Electric Trim Actuator Kit includes a 12v Electric Linear Actuator, 2 control relays, 6ft Trim Cable, Cable End, Cable Extension, Mounting Plate, Cable Travel Arm, Cable Mounts and Installation Hardware.
This kit will still require Momentary Switches which we sell separately.
HD Battery Retainer Strap Pair
Much stronger and slightly shorter than OEM straps which takes away the slack when using aftermarket batteries. 10 inches total length (hook to hook).
These straps can be added to the Minijet Battery Box incase your donor PWC does not have OEM straps to use.
(Battery Box sold separately).
Minijet Bilge Pump Mounting Plate
The Minijet bilge pump mounting plate simplifies the mounting and installation of automatic bilge pumps in all compatible Minijet hulls and stringers. The bracket recesses the bilge pump into the stringer cavity, placing the pump pickup at the lowest possible spot in the bilge. Pump mounting holes and are pre-drilled and ready for suitable rivets.
We also offer this mounting plate as part of a complete bilge-pump kit.
